6002-ZZ-SKF - Deep groove ball bearing - 6002 zz

NTN 6202Z 62 Series Round Bore Standard Small Deep Groove Radial Ball Bearing, 15 mm Dia Bore, 35 mm OD, 1 Rows, 11 mm W, 7750 N Load

These suffixes mean "with 1 or 2 rubber seals". At 123Roulement, we use the number "2" to specify when the bearing is sealed on both sides.

These suffixes mean "with 1 or 2 sheet metal deflectors", for dust-tightness. At 123Roulement, we specify whether the bearing is sealed on 2 sides with "ZZ".

These suffixes indicate that the cage (the part of the bearing that holds the balls apart) is made of polymer material. Usually made of glass-fiber-reinforced polyamide.

This suffix indicates that the bearing is designed for very high operating temperatures. In general, the temperature is indicated after this suffix.Beware, these bearings are not suitable for all applications, and will require a high temperature for optimum service life.

The Deep Groove Ball Bearing, known as 62205-2RS-C3-FAG FAG, has an inner diameter of 25 mm, an outer diameter of 52 mm and a thickness of 18 mm.

A stainless steel bearing is generally magnetizable, as it is made from AISI 420 stainless steel, which is harder and more shock-resistant than standard stainless steel (AISI 304).To check whether your bearing is made of stainless steel, simply read the reference engraved on the side of the bearing. This reference should begin with the prefix "S" meaning "Stainless Steel".

Deep groove ball bearings are very widely used. A deep groove is formed on each inner and outer ring of the bearing enabling them to sustain radial and axial loads in either direction as well as well as the complex loads which result from the combination of these forces. Deep groove ball bearings are suitable for high speed applications.

Means "increased internal clearance". Often referred to as high-speed, this means that the bearing is designed for high rotational speeds and moderately high temperatures. CAUTION: a bearing with increased internal clearance will not operate optimally at low speeds. Please refer to the data sheet for the bearing you are looking for to find out its rotation speed limit.

NTN Deep Groove Radial Ball Bearing, Round Bore Standard Small, Series: 62 Series, 15 mm Bore, 35 mm OD, 1 Rows, 11 mm Width, Single Shield Closure, 7750 N Load, High Carbon Chrome Steel Bearing, Pressed Steel Cage, 19000 rpm Grease/23000 rpm Oil Maximum, -40 to 120 deg C

The ABEC standard is used to classify bearings according to their machining tolerance. This standard is regularly called into question because it does not include certain technologies that are important for guaranteeing proper operation, both in terms of efficiency and bearing life.123Roulement therefore makes little use of this standard.

The Deep Groove Ball Bearing, known as 62205-2RS-C3-FAG FAG, has an inner diameter of 25 mm, an outer diameter of 52 mm and a thickness of 18 mm.

The Deep Groove Ball Bearing, known as 62205-2RS-C3-FAG FAG, has an inner diameter of 25 mm, an outer diameter of 52 mm and a thickness of 18 mm.

Some bearings are available with more or less important variants (high or low internal clearance, special grease, very high temperature, etc.). These variants are systematically indicated by prefixes and suffixes in the part number.For example, the suffix "2RS" means that the bearing is splash-proof, thanks to a sealing flange on both sides of the bearing.The suffix "C3" means that the bearing has increased internal clearance, and will require a higher operating temperature, or a higher rotation speed.