Pesticides approved for professional use must only be used by users holding the relevant specified certificate(s). (Section 8 (1), The Plant Protection Products (Sustainable Use) Regulations 2012) (Part III of the Food and Environment Protection Act 1985, and related Codes of Practice).

A stainless steel bearing is generally magnetizable, as it is made from AISI 420 stainless steel, which is harder and more shock-resistant than standard stainless steel (AISI 304).To check whether your bearing is made of stainless steel, simply read the reference engraved on the side of the bearing. This reference should begin with the prefix "S" meaning "Stainless Steel".

If you are shopping from an EU Country and do not have a VAT/EORI number unfortunately we will not be able to supply due to new EU VAT protocols. You will be still able to purchase through our Ebay store.

We accept no liability whatsoever for any injury or damage to persons, property or the environment where a product purchased from us is applied by a person without the prescribed qualifi cations and /or not in accordance with the product label and / or instructions supplied with the product.

The Deep Groove Ball Bearing, known as 62207-2RS-SKF SKF, has an inner diameter of 35 mm, an outer diameter of 72 mm and a thickness of 23 mm.

Means "increased internal clearance". Often referred to as high-speed, this means that the bearing is designed for high rotational speeds and moderately high temperatures. CAUTION: a bearing with increased internal clearance will not operate optimally at low speeds. Please refer to the data sheet for the bearing you are looking for to find out its rotation speed limit.

Image

This suffix indicates that the bearing is designed for very high operating temperatures. In general, the temperature is indicated after this suffix.Beware, these bearings are not suitable for all applications, and will require a high temperature for optimum service life.

These suffixes mean "with 1 or 2 sheet metal deflectors", for dust-tightness. At 123Roulement, we specify whether the bearing is sealed on 2 sides with "ZZ".

Image

The Deep Groove Ball Bearing, known as 62207-2RS-SKF SKF, has an inner diameter of 35 mm, an outer diameter of 72 mm and a thickness of 23 mm.

These suffixes indicate that the cage (the part of the bearing that holds the balls apart) is made of polymer material. Usually made of glass-fiber-reinforced polyamide.

The Deep Groove Ball Bearing, known as 62207-2RS-SKF SKF, has an inner diameter of 35 mm, an outer diameter of 72 mm and a thickness of 23 mm.

The ABEC standard is used to classify bearings according to their machining tolerance. This standard is regularly called into question because it does not include certain technologies that are important for guaranteeing proper operation, both in terms of efficiency and bearing life.123Roulement therefore makes little use of this standard.

Some bearings are available with more or less important variants (high or low internal clearance, special grease, very high temperature, etc.). These variants are systematically indicated by prefixes and suffixes in the part number.For example, the suffix "2RS" means that the bearing is splash-proof, thanks to a sealing flange on both sides of the bearing.The suffix "C3" means that the bearing has increased internal clearance, and will require a higher operating temperature, or a higher rotation speed.

As from 26th November 2015 it is an offence for anyone to purchase pesticides authorised for professional use unless they have ensured that the intended end user holds the relevant specified certificate(s). (Section 9 (5), The Plant Protection Products (Sustainable Use) Regulations 2012)

These suffixes mean "with 1 or 2 rubber seals". At 123Roulement, we use the number "2" to specify when the bearing is sealed on both sides.