A-Premium Rear Wheel Bearing and Hub Assembly ... - jeep compass wheel bearing replacement cost

2024-08-13 15:05:10

I installed new bearings inmy 96 Legacy and it made noise right away even with the new Subaru bearings, meaning the hub was hosed. They made it 20,000 miles before giving out again this year. It kept the same general noise level for 20,000 miles. As soon as it started getting worse, it got worse quickly. Once it started getting worse, we probably put 500 miles on it before it got to the point the car was wandering and dangerous. So in my case - 500 miles once the noise started to change/get noticeably worse.

How longdowheel bearings laston a trailer

If it starts to change and aget worse, i would lean towards the caution area. Mine got rather scary when it started to drift, pull, and wander on the road and that was just a rear bearing.

More than just noisy or bothersome, bad wheel bearings could also lead to real performance issues like inconsistent braking, spongy steering and handling, uneven tire wear and, in extreme cases, the wheels could fall off. No matter how much (or how little) you know about cars, you don’t want the wheels falling off, right?

I had a really noisy bearing in the head of a mill last summer. When I got it apart, it turned out to be one of the bearings on the motor shaft. It was a ball bearing and the balls appeared to be in good shape with just the slightest hint of wiggle indicating it was bad. But the section of shaft that the bearing was pressed onto was so wrinkled and distorted that one had to wonder if it was ever hardened. It was made overseas so I suppose one still should wonder, but assuming it was, that's at least one example of a bearing seat getting hammered. If I had tried to press a new bearing on that shaft, I'd be replacing it inside a month I'm sure.

The short answer is: Not for too long. Having bad wheel bearings can range from inconvenient and unpleasant to downright dangerous.

When towing a boat trailer, it is a common practice to check for failed wheel bearings by touching the hub. A very hot hub can mean a failing bearing. The disc brakes on a Subaru will normally generate quite a bit of heat. Could you use use hub temperature, say one hub is WAY hotter than the one on the other side of the car, as a fast and dirty checlk on the road?

It already is giving you a warning sign, its noisey. Its sort of like asking if your chest pains are a warining sign of a heart attack. By the time your asking it may be too late.

Howmanywheel bearingsdoes a car have

I just took my 2005 OBW (57,000 miles) into the dealer today. I started hearing low humming sounds from the rear, and over the course of a month it slowly progressed to the sound a truck makes with aggressive oversized tires. I also started noticing it was a little harder to keep the car straight...almost like a strong wind blowing perpendicular to the car while on the highway at all times.

How longdo rearwheel bearings last

Dave, I also have the 20 ton H.F. press. I hope yours comes with the new plates. Mine came with the flat ones, but the other day when I was in the store I see they now have plates that are not flat on one side which would make doing the bearing jobs a lot more easy.

awesome dave, good luck with it! i've thought about doing the same thing, getting that press. i was just afraid i'd have no clue how to use it properly and mess up the hub/bearings.

To find the one that is bad raise the two front tires off of the ground at the same time and spin the wheels one at a time while holding the coil spring. The one that is bad will cause vibration in the spring that you will feel with your hand. If they feel the same then do the back ones the same way. I wish I could credit the one that gave this tip here a few years back but I dont remember who it was.

2001 Forester, 93000 miles on it. Driver's rear wheel ball bearing cracked (yes, one of the balls actually broke in half) during a highway drive on 11/26/8. It was very loud from then until yesterday 4/26/9 which is the earliest I could get to it to fix it. But for us that was only about 1500 miles. There never was any play or wiggle to the wheel.

I have a noisy front (pretty sure) wheel bearing on the right side, its slowly getting louder, I can hear it while going straight and its a little worse going left, quiets completely during a right-hand turn, and I'm starting to be able to feel a little thrumming through the steering wheel and the floor.

For a national average across all vehicles, the average cost to replace the wheel bearings (for 1 wheel) is about $350 (including parts and labor). But KBB.com goes deeper than that. Based on analyzing 100s of actual repair orders, we put together the Kelley Blue Book Fair Repair Range to show you what you should expect to pay for this repair for your Kia. Simply tell us the year, model and style of your Kia and we’ll show you a fair price for the repair.

If it starts to change and aget worse, i would lean towards the caution area. Mine got rather scary when it started to drift, pull, and wander on the road and that was just a rear bearing.

I'm not an expert on wheel bearings or even bearings in general, but as a machinist in a shop that does it's own maintenance, I'll venture a guess.

What causeswheel bearingsto go bad

Budget's been maxed out (as it should be!), I tested the temps (with the back of my hand) on the wheels around the lug nuts after a lengthy drive last night and all were cool, with both fronts slightly warmer than both rears.

If water, grit, salt or sand get to the bearings, the grease in the hub assembly gets contaminated. This will wear down the bearings, and they will eventually give out.

My friends Legacy I just replaced front bearings on last weekend he drove a few hundred miles and it gradually got worse over the past couple weeks, they were quite loose when I pulled the hub Saturday. Don't know mileage though.

How longdowheel bearings laston a truck

For more on any of these complaints – not to mention more than you ever knew you wanted to know about wheel bearings, read the full article

Today the dealer replaced both rear wheel bearings, at no charge, covered under a 100k extended warranty Subaru is offering specifically for the wheel bearing issue.

i bet you got quite a bit of time yet then if it's not showing a temp difference. the temperatures will start destroying the bearing quickly and you haven't gotten there yet.

Recalls may not affect every vehicle of the same year, make and model. Use your VIN or plate to find out if your specific car has open recalls.

In my experience they start with a "wub, wub, wub, wub" kind of sound. Often it's hard to distinguish from road/tire noise.

I am assembling the tools to do the job (I've wanted a press for a long time, heh, harbor freight here I come), and after they arrive I'll do the job as soon as I can determine which bearing it is.

How longwill awheelbearinglastonce it starts making noise

How longdo BMWwheel bearings last

replace it now before the driving season starts, otherwise Mr Murphy will tap on your shoulder, usually after you get the car packed for a trip, the wife/kids are driving, or you really need to go someplace in it.

it will go until it leaves you stranded, or maybe causes an accident at 70 mph. it's not going to stop turning in your drive way or at the shop. it's going to stop on the road.

In theory, wheel bearings could last as long as your Kia. Unlike oil changes or tire rotations, there’s no standard maintenance schedule for replacing them. However, wheel bearings can be damaged if you hit a pothole, smack into a curb or bounce over a speed bump too fast.

Any bearing that has failed, ie has a damaged race, damaged cage, damaged roller/ball, etc, is not going to evenly distribute the centrifugal force and, given enough time, I could see how it would knock the seat (or hub in this case) out of round even ever so slightly. Once the hub is out of round, the new bearing will suffer the same fate as the old since it does not have even support around it's circumfrance.

If you hear noises at the wheels, one explanation might be a need for a wheel bearing replacement at one or more wheels. The noises might be described as rattling, clicking, humming, growling, or squealing. It can be a real symphony of sound if you’re not careful.

Unless both are bad, one manifests as a vibration that is not noticeable when driving, and the other manifests as a classic wheel bearing noise?

20 ton press (yeah, the 12 ton would be enough, but it wasn't *that* much more, and the A-frame one looks cool- and it's best to derate HF tools anyway)

Till it fails (which ttechnically it has already failed). Also you can be destroying the hub, as i have done that many times, and that quickly ups the repair bill. Just fix the thing before you need a bearing, hub, and a tow truck.

Sometimes this happens if the vehicle is brand new, older, the manufacturer no longer makes vehicles, or we just couldn’t get our hands on the information.

In a RIGHT turn the LEFT bearing is more heavily loaded, so I would expect the noise to be worse when the bad bearing is more heavily loaded.

How longdowheel bearings laston a motorcycle

Dave, might be a good time to invest in one of those infrared heat devices, they are sweet. I diagnosed a front wheel bearing last week on a friends car. Drove to my house, hit it with the gun and had it narrowed down in seconds.

i just looked up my spreadsheet - the bearings lasted 17,000 miles after they started making noise. i would guess every case is different, that was during winter, i would guess summer heat would have made it worse.

There was almost no temp difference with a borrowed IR thermometer. One or 2 degrees at most either way, depending on which way the wind blew on the drive.