You are going to want either our Bearing Kit #BK2-100 or the Timken Kit #TMK52VR. Both of these kits will give you the inner/outer bearings and races along with a grease seal and cotter pin/D-washer for one hub. You always want to replace the race…

270cmtoinches

Hey Mark, yeah you can definitely convert the 3,500 lb axles of your 2021 Grand Design Imagine 2500RL to disc using the DeeMax actuator part #DE47SR that you referenced. The correct hub/rotor kit would be the part #DE66YR which you'd need two of,…

The easiest way to determine what spindle your trailer has is to use a dial or digital caliper like the part #PTW80157 to measure it where the bearings and grease seal ride. I attached a picture that shows where these measurements are. If where the…

*1 Length, entire length, and weight values given are for the Nikon mount. Specifications, appearance, functionality, etc., may be changed without prior notice. *2 Length is the distance between the mount face and the tip of the lens. Entire length is the distance between the tip of the lens and the tip of the protrusion. *3 The Sony mount does not include the VC image stabilization functionality, as the body of Sony digital SLR cameras includes image stabilization functionality.

270mm tofeet

The torque for the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles - 12" - 5 Spoke Utility #8-174-5UC3 is not specified by the manufacturer. For 9/16 inch studs, the typical lug nut torque will be 120-140 ft lbs based on most…

We recently bought a new trailer and I re-greased the bearings with GC-LB grease a few months after purchase. Before I re-greased the bearings, they were stone cold after driving about three miles at speeds no greater than 50 mph. Now that I re-greased them, they are slightly warm after the same trip. Is this normal? Thanks

Release Date For Nikon: 2010/12/20* For Canon: 2010/12/20* For Sony: 2011/04/15* * Date of launch in Japan

270mm toinches fraction

Hey Paul, this a great question but the bleeder location on the DeeMax caliper part #DE83YR wouldn't be an issue for use on either side of the trailer. It will still bleed the air out and you wouldn't have to worry about the air not wanting…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Hello Bart, thanks for reaching out. I can definitely point you in the right direction, but I will need a bit more information on your truck before I can recommend the correct tie downs. Can you please answer the following questions for me? 1. What…

Tamron's celebrated VC (Vibration Compensation) just got even better. It still offers great handheld and telephoto shots. It still delivers the renowned VC (Vibration Compensation) stable viewfinder image, and excellent traceability. It's still based on a moving three-coil mechanism that activates the lens group electromagnetically through three steel balls. But technology must evolve. Previously, the heavy magnet was positioned near the lens element and worked very well in this placement. In the new VC (Vibration Compensation) mechanism, we've reversed the positioning of the magnet and connected the lens to the coils. This innovative new position thus achieves less load on the drive and combined with lighter coils, contributes to a lighter, more efficient lens. * VC is an abbreviation for Vibration Compensation, and is also available in the18-270mm (B003), 28-300mm (A20), 17-50mm (B005) and the 70-300mm (A005) models. * The Sony mount does not include the VC image stabilization functionality, as the body of Sony digital SLR cameras includes image stabilization functionality.

290mmtoinches

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high temperatures (like what occur on a trailer hub that has massive RPMs when travelling, even at slower speeds) so it will continue to lubricate instead of quickly dissipating like you see with lower rated greases.The best grease for trailer bearings is the LubriMatic LMX Industrial Strength Grease # L11390 and LubriMatic Wheel Bearing Grease # L11465 which have the highest rating of of GC-LB to give your bearings the protection they need. These cartridges will fit Grease Gun # L30200 or # L30480 and I strongly recommend using Bearing Packer # L70025 or # ALL647646 to make the job much easier. You also want to be sure when you do re-grease your bearings to get rid of all of the grease that had been on the bearings because not all types of grease are compatible.I have added links to video reviews for you to check out as well as a link to an FAQ on bearing grease I recommend taking a look at.

Hello Darren. Thanks for reaching out, I can definitely help with this. To convert your 2024 Brinkley Z2900 5th wheel over to disc brakes, you will need a disc brake kit, a brake line kit, and electric over hydraulic actuator, and a breakaway kit for…

MTF (Modulation Transfer Function) curves describe to what extent the tested lens can faithfully reproduce contrast of the subject in images it captures. The closer the 10 lp/mm (line pairs per millimeter) curve (the thick line for low frequency) in an MTF chart to "1" of the vertical axis (the higher up), the higher the contrast reproduction performance of the tested lens will be. The closer the 30 lp/mm curve (the thin line for high frequency) to "1" (the higher up), the higher the resolving power and thus the subjective sharpness of the lens will be. Lens performance differs depending upon directions. Solid lines show performance in the sagittal (radial) direction while dotted lines indicate performance in the meridional (circumferential) direction. When sharp lenses capable of delivering uniform optical performance over the entire image field are tested, MTF charts show curves plotted in good balance. Performance characteristics of photographic lenses cannot be expressed with only MTF charts. There are other factors that are expressed in different methods, such as taste of softness and degrees of compensation of various aberrations. But you can use MTF charts as a scale to measure lens performance.

260mmtoinches

370mmtoinches

Hey Jeff, based on your axle info the correct bearing kit would be the part #BK3-310 for a kit that includes both bearings #LM67048 and #25580 as well as a grease seal. This would be all that you'd need as you can reuse the dust cover.

The new BBAR (Broad-Band Anti-Reflection) coatings reduce the lens reflection and dispersion that cause ghosting and flare. The coatings enhance light transmission in both the short and long wavelength ranges, ensuring excellent performance in all photographic conditions. Additionally, internal surface coatings are applied to cemented surfaces of all lens elements to deliver sharp, high-contrast images and flawless color reproduction.

270mm toinchestofeet

Hey Eric, the 6-Leaf Double-Eye Spring for 5,300-lb Trailer Axles SP-222275 could work but really to be sure you'd need to measure the length from center of spring eye to center of spring eye (unloaded), measure the leaf thickness, and find out…

The new PZD (Piezo Drive) piezoelectric drive marks another Tamron first in its autofocus SLR lenses, an internal standing wave ultrasonic motor system. Innovations to reduce parts and simplify operation also contributed to the lens's reduced size and weight. Lighter and smaller than other autofocus drives, the piezoelectric drive uses a standing wave, instead of the traditional traveling wave, to turn and extend the piezoelectric element. Thus the entire element moves in a standing wave pattern, moving the metal tip (the contact surface) in an elliptic motion. The friction of this movement moves the rotor for a smooth, precise autofocus.

Hello George. We will undoubtedly have a bearing kit for the 7K Lippert your 2017 Jayco North Point 5th wheel. That said, I do not have a way to tell you the exact seal size based on the info you provided. The best way to find this out will be to…

270mm tocm

We recently bought a new trailer and I re-greased the bearings with GC-LB grease a few months after purchase. Before I re-greased the bearings, they were stone cold after driving about three miles at speeds no greater than 50 mph. Now that I re-greased them, they are slightly warm after the same trip. Is this normal? Thanks

From wide to telephoto, this 15x high-power zoom lens covers a vast focal range, and it does it in a light, compact package. At the telephoto end, the 18-270mm is ideal for sports shots or when using distance to capture wildlife in habitat or natural expressions on subjects who normally would be overly conscious of the camera. Whether on vacation or in your own back yard, the wide end gives you the tools to shoot expansive landscapes. Every angle for photographic expression and all in a lens that delivers sharp, clear photos. In addition, this lens is packed with the best Tamron technologies, which have enabled a significant reduction in body size. The lens construction comprises 13 groups and 16 elements, which is two elements fewer than the previous model, while use of the hybrid aspherical lens with low dispersion glass has helped achieve a compact design and improved optical performance. In addition, the new PZD autofocus drive and the new VC mechanism were developed as downsizing technologies exclusive to Tamron. This has resulted in a compact lens that is 100 grams lighter and 24% smaller in volume compared with the previous model.

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

Designed exclusively for APS-C sized digital SLR cameras, this all-in-one zoom covers every angle. Its minimum focal distance of 0.49m (19.3 in) through the entire zoom range and macro capability to 1:3.8 allows you to enjoy serious, high-quality macro photography with unaccustomed convenience. With an optical system designed exclusively for optimum performance on digital SLR cameras with APS-C size image sensors, the angular coverage range of this lens is impressive. And even though it has built-in VC (Vibration Compensation), it still delivers a close minimum focus across the entire zoom range. From macro to telephoto this is a lens worthy of your creativity. Light, compact, smooth, and accurate at every angle. * APS-C size image sensors are smaller than the 35mm film format. This lens can produce full-screen images of almost the same scale (approx. 8cm x approx. 5.5cm) as those taken with a 35mm format camera with a lens of maximum zoom ratio of 1:2.5.