The 39-piece bearing installation tool set made of heavy-duty steel from the series 71 is used for the installation of bearings using a hydraulic press or hammer in crafts, industry, and workshops. The set includes 33 impact rings and 5 impact tubes made of extra strong steel, as well as 1 SELCTHOR with two different impact inserts (PU/CA). The tool set allows for a damage-free installation of bearings without damaging axles, bearing housings, or seal rings.

Static loadvs dynamicload

The basic static load rating for radial bearings is specified as the basic static radial load rating, and for thrust bearings, as the basic static axial load rating. These load ratings are listed in the bearing specification table, using C0r and C0a respectively. These values are prescribed by ISO 78/1987 and are subject to change by conformance to the latest ISO standards.

Static loadexamples

Excessive static load or impact load even at very low rotation causes partial permanent deformation of the rolling element and raceway contacting surfaces. This permanent deformation increases with the load; if it exceeds a certain limit, smooth rotation will be hindered. The basic static load rating is the static load which responds to the calculated contact stress shown below, at the contact center between the raceway and rolling elements which receive the maximum load.

I accept to receive e-mails and/or text messages. I understand that I can unsubscribe at any time after I have registered.

You have questions about the application of the product? You are not sure which item you need? No problem! Just write us a message and we will be happy to help you!

Static loadformula

Our professional distributors are available for on-site support and personal advice. Thanks to our global network, you are sure to find a partner just around the corner.

The static equivalent load is a theoretical load calculated such that, during rotation at very low speed or when bearings are stationary, the same contact stress as that imposed under actual loading condition is generated at the contact center between raceway and rolling element to which the maximum load is applied. For radial bearings, radial load passing through the bearing center is used for the calculation; for thrust bearings, axial load in a direction along the bearing axis is used.

Static loadand dynamicloadexamples

Do you have a request? We will help you with your request, and work together for the correct solution. Please choose one option to contact us:

Static loadand dynamicloadcalculation

The total extent of contact stress-caused permanent deformation on surfaces of rolling elements and raceway will be approximately 0.000 1 times greater than the rolling element diameter.

Image

71 | Bearing installation tool set made of steel, black version, for ball bearings with an inner diameter of 5-10 mm, outer diameter of 26 - 110 mm

The allowable static equivalent load for a bearing is determined by the basic static load rating of the bearing; however, bearing service life, which is affected by permanent deformation, differs in accordance with the performance required of the bearing and operating conditions. Therefore, a safety coefficient is designated, based on empirical data, so as to ensure safety in relation to basic static load rating.

Image

Image