The F-2XX series flange bearings are designed to rotate within their housing which gives you some lee-way on positioning the shaft and bearings on each end.  For obvious reasons, we recommend that they are installed as straight and level as possible, but in case you're a little off, these bearings will give you a small amount of forgiveness if things aren't perfect.

Schrader valvefuel pressuregaugeadapter

For maintenance, we recommend greasing the bearings at least once per year through the installed grease zerk, and they should last just fine for a long time.

The F207 is a 1-1/4 inch diameter flange bearing that works great for end-to-end rotating shaft needs like the agitation of sealcoating tanks.  If you've purchased one of our BIGA tanks in the past and need a replacement, these are the ones we use and will bolt up without a problem.

Fuel Pressure AdapterFitting

Just make sure to click the checkmark next to the gasket accessory before you hit the add-to-cart button and you're good to go.

Toyota fuel pressuretester

Whether you're repairing your tank or building your own, pair the flange bearing with a rubber gasket to ensure your tank doesn't leak.

While this is advertised as a sealcoating shaft seal bearing, this part can be used in a wide variety of industrial applications.

If you're building your own, we've used these bearings for well over a decade on our sealcoating tanks and haven't had any problems with them outside of the normal wear-and-tear.  Keep in mind, the OD of the shaft pipe or rod can not exceed 1-1/4" and we actually recommend using a shaft that is slightly smaller for easier fitment. If you need larger than 1.25 inch, you might want to look at the 1-1/2" flange bearing instead.

Sorry, we just need to make sure you're not a robot. For best results, please make sure your browser is accepting cookies.