2013 Dodge Dartfrontwheel bearingreplacement

2013 dodge dart wheel bearingsize

where L10 = bearing life in hours at 90 percent reliability, C = bearing dynamic rating, P = bearing load, and e = 3 for ball bearings and 10/3 for roller bearings.

In most gearbox applications, there is not one single torque and speed that the gearbox operates at but a series of torques and speeds and time intervals at each condition. These various conditions constitute data points on a duty cycle and together, they must be considered in their entirety.

Got the rear wheel bearing assembly off the car and the race is still stuck to the post. Cannot get it off and I need it off to put the new assembly on, any advice would be appreciated.

Both gears and bearings are typically sized, and life is calculated based on the duty cycle from what is known as the weighted average torque and speed that represents a single torque and speed which would produce the same life as would be achieved if the system operated at the full duty cycle of torque speeds and percent times.

2013 dodge dart wheel bearingreplacement

For a duty cycle where there is variable torque (load), speed, and percent (fraction) of time, the weighted average bearing radial load or torque is:

So, either the L10 bearing life must be calculated only once as in the first example formula or calculated for each part of the duty cycle, as in the last formula.

Keep in mind that these are ABMA life formulas, or so-called catalog life values, and do not consider or use any adjustment factors, such as those used for lubrication, cleanliness, or other factors.

2013 Dodge DartRearWheel bearingreplacement

The main item to remember and consider is which type of bearing you are analyzing. Ball bearings use 3 and 1/3 as exponents in the equations and roller bearings (tapered, spherical, and cylindrical) use 10/3 and 3/10 for exponents.

Normally, it would have been necessary to use a value of S (speed) in both the weighted average load calculation and the bearing life calculation, with the value of S being the same in both places.

It would seem that this value of S would be important to the resulting life and that a weighted average speed would be required for this equation, but that is not the case. There is no requirement to calculate or use a weighted average speed in this formula, and since the speeds cancel each other out, any speed used would produce the same result. The differing speeds for the different points on the duty cycle are taken into account and reconciled in the weighted average radial load(force) calculation for P.

Got car questions? If you're having an emergency, please call emergency services. Please see the posting rules for this sub. Stay safe on the roads!