WARNING! Don’t continue to use bearings that don’t spin freely on your skateboard. If you continue to ride very dirty or un-lubricated bearings, you run the risk of permanently damaging them and/or yourself. Dirt in your bearings will cause pitting of your balls and races, increase friction, cause extra heat, and can eventually cause the bearing to “freeze up” or stop rolling. If this happens to your bearings, the skateboard will stop abruptly, causing you to fall and be injured. So keep them clean, dry and lubricated with Speed Cream.

How to clean skateboard bearingsat home

JavaScript seems to be disabled in your browser. You must have JavaScript enabled in your browser to utilize the functionality of this website.

High precision bearings like Bones® roll their best after about an hour of use in a clean environment (this initial use is called a “break in period”). If you want your bearings at their peak prior to a competition or a race, we highly recommend you break in your bearings, then clean and re-lubricate them and store in a moisture free container until you are ready to use them. When storing your bearings, be sure there is a light coat on the outer races with our Bones Speed Cream®, or a light oil to prevent them from rusting.

How to clean skateboard bearingsreddit

Your new Bones® Bearings are the most accurately manufactured part of your skateboard, with clearances and tolerances considerably smaller than 1/1000th of an inch. That means that a single hair is thicker than the clearance between the balls and the races inside the bearing, and a hair will clog it up and slow you down. Because you skateboard outside through dust, sand, water, mud, etc; your bearings will eventually get dirty and/or wet. When they are dirty, you will notice they don’t spin freely when you flick the wheel and you may also notice they are getting noisy. At this point you have two options: clean your bearings or replace them.

Note: We have attempted to foresee any possible problem you may have during your cleaning process, and so these instructions may seem complex at first reading. The bearing cleaning process is logical and simple though, and you should have no problem doing this if you can understand our sequential steps.

Congratulations on acquiring a set of Bones ®Bearings, known world-wide as the best brand of skateboard bearings available. All Bones® Bearings are Skate Rated™ to our precision “tolerances” to give you the absolute maximum speed and life possible, not “ABEC” rated like bearings designed to operate in motors or normal machinery. The superb quality of Bones® chromium bearing steel races with their mirror like “super finish,” removable, non-contact rubber shields, high speed, precision molded ball retainers, and Bones Speed Cream® lubricant provide unequalled roll and ease of maintenance. So, carefully install them in your wheels and you’re ready to roll.