We are committed to ensuring that our website is accessible to everyone. If you have any questions or suggestions regarding the accessibility of this site, please contact us.

Wheel BearingcostAutoZone

This document provides general sharing economy principles. It is intended to be used by all types and sizes of organization (e.g. commercial enterprises, government agencies, not-for-profit organizations).

Hub bearings are readily available online and at auto parts stores. Opting for a less expensive option should still work well. A competent mechanic can usually install them for much less than a dealer would charge. The main challenge is that they can be difficult to remove if they’ve rusted into the hub.

Wheelbearingsreplacementcost

Labor for both sides is listed as 2.2 units under manufacturer warranty and 2.8 units for standard service. A hub bearing for one side costs around $154 for an OEM part.

Front wheel bearing replacementcost

It is intended to be used by all types and sizes of organization (e.g. commercial enterprises, government agencies, not-for-profit organizations).

All ISO publications and materials are protected by copyright and are subject to the user’s acceptance of ISO’s conditions of copyright. Any use, including reproduction requires our written permission. All copyright requests should be addressed to copyright@iso.org.

Rear wheel bearing replacementcost

1 No Poverty 11 Sustainable Cities and Communities 3 Good Health and Well-being 9 Industry, Innovation and Infrastructure

It seems that both procedures are charged at a flat rate of 4 hours. Wheel bearings cost about $100 each, with labor around $100 per hour, so you are looking at roughly $600 in total. If you can remove the steering knuckles yourself and take them to a shop, and use aftermarket or discounted factory bearings, you might reduce the cost to just over $300, assuming you don’t need new hubs. If hubs are required (and Camry hubs often slip and wear out), expect the total estimate to increase by around $200.

This standard contributes to the following Sustainable Development Goals 1 No Poverty 11 Sustainable Cities and Communities 3 Good Health and Well-being 9 Industry, Innovation and Infrastructure

It was for my front driver side wheel bearing assembly and the axle on the same side. I’m not sure why others quote 4 hours for this job. Sent from my iPhone using Tapatalk

I use Timken bearings from RockAuto, which are often reboxed OEM NSK or Koyo, costing about $35-40 each. Press work is roughly $40 per side, plus a four-wheel alignment afterward. However, you’ll need to be mechanically skilled and have the right tools to do this yourself.

I went to a local mechanic, who charged $100 for each bearing and $100 for each installation, totaling $400. Additionally, the alignment costs between $60 and $100, so expect to pay around $500. This is a good opportunity to replace any other worn parts, such as shocks or outer tie rods, since you’ll need an alignment.