FPSO turret bearings present a number of known and predictable problems which can result in serious damage to bearing pistes, including bearing pads becoming ...

UCP205-16 Plummer block housing unit at Schaeffler medias ▻ View all product data here & buy online.

12470. As to directors elected by members, there shall be available to the members reasonable nomination and election procedures.

The internal wiring of the CCD can become disconnected in high-temperature or high-humidity environments. Canon issued a recall in October 2006. The damaged CCD displays purple or blueish, distorted or possibly no image at all. The menu and pictures taken prior to the CCD disconnect will still display normally.[20][failed verification][21]

Our experienced bearings specialists are on hand to offer practical solutions to your problems and can assist with an on-site visit.

The original design had 25mm bolts in originally and they vibrated loose in short order. Done some reading on the topic and 50mm bolts should be the right ...

The Digital IXUS series slots above the PowerShot A in Canon's point-and-shoot lineup, with models in the Digital IXUS range commanding a considerable price premium.[9] However, since the late 2000s, with the falling prices of Digital IXUS models in Canadian and U.S. markets, they have become among some of the lower-priced models available as PowerShot A models are gradually withdrawn from the market and not replaced.

A firmware bug exists that can cause the IXUS 400 (and possibly other cameras with the same firmware) to display a "Memory card error" message after the camera has been in use for some time. Contrary to the message, there may not actually be anything wrong with the memory card. Descriptions of the fix recommend simultaneously removing the internal and external batteries to reset the camera.[72] Canon has acknowledged this issue and formerly repaired it free of charge.[73]

All models introduced before 2010 use RGBG Bayer filter (except the original Digital IXUS, which uses a CYGM filter[5]) CCD sensors made by Sony. IXUS 300 HS/PowerShot Digital ELPH SD4000 IS/IXY 30S introduced in May 2010 and all following models have back-illuminated CMOS sensor. Images are recorded as JPEGs. Raw image files are not accessible without the use of third party firmware such as CHDK.

The IXUS 901Ti was the first in a series of IXUS and S-series cameras that feature the Digic image processors and larger than average sensors as fitted to the advanced PowerShot G-series cameras. The IXUS / S-series and the equivalent G-series models are listed below:

The Digital IXUS (IXY Digital in Japan and PowerShot Digital ELPH in US and Canada) is a series of digital cameras released by Canon. It is a line of ultracompact cameras, originally based on the design of Canon's IXUS/IXY/ELPH line of APS cameras.

CR453879 CR Hub Cap Plug. $20 Order Discount when you order $200 or more of genuine Goodyear Air Springs, Firestone, or Hendrickson Air Springs!

Like all compacts with a zoom lens, cameras in the IXUS range are susceptible to the "lens error" message if the lens is physically unable to zoom in or out. On Canon cameras, this manifests as the E18 error or the message "Lens error, restart camera" on more recent models.

Canon's PowerShot A and S line of the time[when?] were being made as small as contemporary technology allowed,[1] and demonstrated the demand for a small digital camera of good quality. Canon used its experience with small film cameras, particularly the APS IXUS, to mass-produce good digital cameras smaller than anyone else had managed up to the time (the first Digital IXUS was the smallest 2 MP then available[2]) and reused the popular IXUS/IXY/ELPH brand name with the tag line "The DIGITAL IXUS blends Canon's award-winning IXUS design with PowerShot digital technology."[3]

Each pair of of wheels has front wheel bearings and rear wheel bearings. They allow your wheels to spin with minimal friction. If your bearings are bad you ...

Several models have found favor within the Kite Aerial Photography (KAP) community due to a unique combination of small size/ low weight, excellent image quality with stabilization, and the option of expanded manual control including intervalometer functionality available via 3rd party CHDK.

Jun 24, 2008 — The wheel well liner was RUBBING. The "wheel rub" can and does produce a similar sound at low speed, tight turns - like the clutch pack binding.

Double row deep groove ball bearings correspond, in their design and operation, to a pair of single row deep groove ball bearings. They are robust in operation, requiring little maintenance, can operate at high speeds and accommodate radial and axial loads in both directions. They are slightly wider than single row bearings of the same bore and outside diameter but have a considerably higher load carrying capacity.• Versatile and robust design• High-speed capability• Accommodate high axial and radial loads in both directions• Require little maintenance

The first Digital IXUS, released in June 2003 fitted the technology of the PowerShot S11 into a body similar to the APS IXUS II.[4] Between 2004 and 2005, starting with the Digital IXUS II, Canon moved from the use of CF cards to SD cards to create thinner cameras.

A number of camera models across several manufacturers used a Sony CCD that was prone to failure. Canon put out a general recall in late 2005 on affected models and serial numbers.[74][75] Models from the IXUS range are the v3, II, and IIs. Canon has issued a support advisory stating it will repair affected cameras free of charge.[76][77] This free repair service for Canon cameras with defective CCD image sensors is gradually being phased out; in the UK, the free service end date for IXUS II cameras was 31 January 2011.

The 32048 SKF is a single-row tapered roller bearing. This bearing type gets its name from the tapered rollers between the inner and outer rings. The raceways ...

The Canon Digital IXUS 430 is (PowerShot ELPH S410 in North America and IXY Digital 450 in Japan) featured 4.0 megapixels, 3x zoom lens, and i3 minute videos with sound.[citation needed]

There has been a Service Notice by Canon stating that the vendor supplied CCD image sensor used in this camera can cause a malfunction.[22] The affected cameras (s410) show the symptoms such as a corrupted image, lines going across the LCD screen, lack of color of the image produced, or no image produced. Shots by the camera will also display these symptoms.[22] In Canon's service notice they also stated the following: "Effective immediately, and regardless of warranty status, Canon will repair, free of charge, products exhibiting the above-mentioned malfunction if the malfunction is caused by the CCD image sensor. Canon will also cover the cost of shipping and handling in connection with this repair."[22]

In 2010, Canon dropped the prefix "Digital" as well as suffix "IS" (Image Stabilization) from the names of the new models e.g. IXUS 105.[6] A similar change was applied to the IXY-series names used in the Japanese market.[7] The United States market naming was simplified in 2011: "Digital" and "IS" were removed as well as "SD" prefix.[8] Newer US and European model carry "HS" suffix, that stands for "high sensitivity".

The same camera models are released in Europe, the US, and Japan under different names. The cameras themselves are identical apart from the front fascia, according to the parts lists. The Canon model number on the bottom is consistent between marketing names. This article uses the Digital IXUS model names unless otherwise stated. The comparison tables in this article list equivalent IXY Digital and PowerShot Digital ELPH model names.

2019717 — 15 years of lifespan for the wheel bearings. i guess this means ca. 1 million of kilometers if your average speed is 100 km/h.

The camera also incorrectly reports a problem with the memory card (Memory Card Error message). This problem can be temporarily overcome by removing both the main battery as well as the small internal battery. Canon has acknowledged this issue, and formerly repaired free of charge.

A wheel bearing replacement can cost $290 to $475+ depending on the location of the bearing and whether it requires pressing in and out of the hub assembly.