Cs205l

For those absolutely stupid things that you see people bring, roll, or toss into your place of business and the people that bring them in.

CS229

NTN Deep Groove Ball Bearing, Tight Fit Round Bore, Series: CS2, 25.4 mm Bore Dia, 52 mm Outside Dia, 1 Rows, 15 mm Width, Double Sealed Closure, 14000 N, Hardened Steel Bearing, Nitrile Rubber Seal, Pressed Steel Cage, -40 to 120 deg C, Uncoated

NTN CS205-100D1V14 Tight Fit Round Bore Deep Groove Ball Bearing, 25.4 mm Dia Bore, 52 mm OD, 1 Row, 15 mm W, 14000 N Load

CS224n

Deep groove ball bearings are very widely used. A deep groove is formed on each inner and outer ring of the bearing enabling them to sustain radial and axial loads in either direction as well as well as the complex loads which result from the combination of these forces. Deep groove ball bearings are suitable for high speed applications.

We typically charge .75 - 1 hour per u joint and don’t charge for drive shaft removal. And also will include the diagnostic time.

CS224W

I feel like each u joint should cost atleast an hour because it is an aggravating job and has high margin for error like bending / dinging the driveshaft or yoke. Often times requires a torch.