ee-8 field phone manual

The AV-grade power adaptor has been designed to reduce electrical noise from AC power and prevent mains quality issues from affecting the network signals. It also boasts high power efficiency, a no-load power consumption < 0.075W and protection from short circuit, overload and over-voltage.

Silver is a lustrous white, ductile, malleable metallic element, having the highest thermal and electrical conductivity of the metals. It is widely used in coinage, photography, dental and soldering alloys, electrical contacts, and printed circuits and jewelry. Atomic number 47; atomic weight 107.868; melting point 960.8°C; boiling point 2,212°C; specific gravity 10.50 g / cm^3. Standard purity is 99.95%. Also available as 99.99% pure, 99.999% pure, and alloyed with copper as Sterling Silver (92.5% Silver, 7.5% Copper) and Coin Silver. Silver is available in sheet, rod, tube, casting pieces, powder and shapes. Many items are in stock or have short fabrication times. Contact us to find out more.

How to fixee8

The products below are representative of what we sell. If you don't find what you're looking for, please request a quote or contact us.

Unfortunately a good psu will cost as much or more than the switch, i use a Plixir on my Etheregen switch. I have heard excellent reports of the Ferrum Hypsos……you can vary the voltage and listen and decide what voltage sounds best to you. But at a price £1100.

Pretty sure MCRU do a supply for it, they are very good, not as much as £1100 but still quite expensive compared to the switch itself

EE8Field phone

I use the Silent Angel Forester F1 power supply that is designed to partner the EE8’s base switch, the Silent Angel Bonn 8.

Java EE 8

Ee8blower motor

Switches require high speed power supplies so we could not opt for a linear power source due to their speed limitations. We set about improving the power signal by using an extremely high-quality wall supply. This clean supply permits an optimum quality network signal, driven by high-accuracy TCXO clock technology.“

I see through google that the LHY LOS25V is a Chinese linear ps. So I don’t understand your post, neither share your point that linear ps tend to reduce the prat and timing. Apart maybe the cheap ones.

ee-8-b

Uptone wrote exactly the same about their Etheregen switch, saying that their SMPS is very good and no need for an additional ps. When I tried their entry level linear ps, the Lps , it did just a subtle uplift in sound vs the stock one. But when I added the top MCRU, the upgrade was even bigger than going from the Cisco 2960 to the Etheregen. Naim Audio himself doesn’t recommend a boutique switch, just a cheap Chinese Netgear one. We are a lot here to experience the contrary.

Adding their cables and recommended fuse upgrade(s) takes things a (very) clear notch up still. Odd as it may sound, adding the Super 3 made a bigger improvement to the overall SQ than the EE8 itself.

When I had the Etheregen switch, I could compare the Uptone Lps vs the top MCRU vs the Farad . The two last were easily above the Uptone lps. I preferred the MCRU ( around 850 euros) vs the Farad ( 700 euros) for nicer tones and more organic sound. The Farad is the nicest looking. There are other to consider, as the Uptone JS1 , Sean Jacobs, Paul Hynes SR4, Plixir. To really see a nice and clear improvement, you have to pay more than the EE8 switch, in my experience.

EE-8 field phone parts

Ee8toyota

Appreciate it’s my decision and it could be a gnats hair between them but any counsel on the 3 options on the MCRU would be appreciated.

I’m using the iFi power elite and I like the uplift. I didn’t compare it to anything else however. It was essentially a free upgrade as I used an Amazon gift card someone sent me.

Despite reading the threads I’m a little bamboozled with regards to power supply for the EE8 - sounds like the general consensus is that adding a power supply is worthwhile.

I think a usual mistake when measuring SMPS claiming their good is you measure them only towards the DC side. That’s great when all you care for is the performance of your single component. What many SMPS do is poluting the AC side which all your other components work against.

Farad super3. Buy and try going through their web page. Skip the Ifi switched power supply and go directly to a linear one. Naim products hate switched power supplies on their grid.

It’s not practical to demo these but I do hear the benefit of adding a Plixir power supply to my Adot and that’s what got me interested in power supply’s generally.

I was told by the guys from Chord that they really rate the SMPS that comes with the EE8 switch. I have to say, after having tried three quite expensive linear power supply’s, that they may be right. All sounded different but not necessarily better on my system. Each seemed to impact timing slightly making it sound less real and musical. I’m not giving up but make no mistake the standard PS is pretty good.