Tax rates can vary within a county, a city, or even a ZIP code. Using a street address helps to ensure more accurate rates and calculations when compared to relying on broader geographic indicators.

Catastrophicwheel bearingfailure

I want to know what could be the various causes for this. Is it just that the wheel/lug nuts haven't been torqued down proplery or could it be caused by a worn wheel bearing, could the studs/hub itself became worn over time or could there be issues with other components such as driveshaft etc. My mechanic told me he's seen this with older hondas so could be a the hub just wears over time.

I'd remount the wheel first and check for play in the bearing and any roughness when turning the wheel. Check the stud holes on the wheel for wear.

How to tell whichwheel bearingis badwhile driving

A wheel bearing failure can, indeed, cause the wheel to fall off. Mine did last week. New tires were put on last fall, and all lug nuts were torqued accordingly. This was with drum brakes. Wheel bearing failure in your case would have taken out the rotor and caliper as well. I would agree with others that either wheel stud failure or improper torque procedures resulted in your wheel going further than your vehicle.

The car is at 160k miles(probably more as in UK apparenty people tend to clock these. If it was due to worn bearings or studs its possible the other wheels could follow. Should I change all or not?

Stack Exchange network consists of 183 Q&A communities including Stack Overflow, the largest, most trusted online community for developers to learn, share their knowledge, and build their careers.

*Rates are rounded to the nearest hundredth. Due to varying local sales tax rates, we strongly recommend our lookup and calculator tools on this page for the most accurate rates.

How long willa wheel bearinglast after it starts making noise

Pretty much the only reason the wheel would fall off is because the wheel nuts weren't torqued. I've never seen one fall off because of a worn wheel bearing. The stud and nut threads can stretch from over tightening.

How long can you drive onabadwheel bearing

Wheel bearingreplacement cost

32205 sales tax details The minimum combined 2025 sales tax rate for 32205, Florida is 7.5%. This is the total of state, county, and city sales tax rates. The Florida sales tax rate is currently 6.0%.

Frontwheel bearingnoise symptoms

I personally would sue the last one that touched this (except it was me). And I would immediately get another mechanic, just because he mentioned that something like this could just happen with age.

You can install new studs IIRC, you don't have to replace the hub. There are some cars where there isn't enough space between the hub and knuckle, so you'd have to pull the hub and replace the studs and bearing.

If your concerned about the other wheels, pull the nuts off, make sure that the wheel sits flush, and doesn't bind due to oxidation when reinstalling the wheel.

First of all: Depending on your speed at the time of the incident the damaged hub is not your biggest thing to worry about. (and yes, in most cases there ought to be replacement studs for the hub)

Bottom line: Bolts/Nuts do not wear by normal use. Textbook root cause are under-torqued lug nuts. The bearing of a hub wears, but cannot provoke the separation of the wheel from the hub.

Look up the current rate for a specific address using the same geolocation technology that powers the Avalara AvaTax rate calculation engine.

It was untightened lug nuts, period .Unfortunately , I have done that. Miraculously , I can tell about it. Just as your photo ; all my nuts were missing, 2 studs had broken by fatigue. I had a Nissan Titan , 6 lug aluminium wheel. I rotated tires for a trip, forgot to torque one front wheel. Drove about 1100 miles on interstate, 60 to 75 mph. I felt a vibration toward the end of the trip; So when I got on my sons' driveway , I got out to remove the problem wheel. I was very shocked to find NO nuts. We pulled the wheel off and found 2 studs had fatigued off. A couple other studs has minor thread damage.We pressed out all the studs and pushed in new ones. Because my wheel did not fall off the only parts I needed were studs and nuts. My son has now driven the truck about another 100,000 miles with no related problems. So, other than repairing your damage , I doubt that anything else needs work.