The banded style of the T-100 series typically allows more balls per bearing, thus providing greater thrust capacity than a 3 piece retained style bearing of similar dimensions.

Locknut types

Before supplying any goods or services, please validate the company details as well as the order with the respective company' s representative. Please find below our various company's contact details. Should you have any concerns, please do not hesitate to contact Invicta Holdings Limited by telephone, email or our contact us form. - Scams to watch out for. Click Here - Supply Chain Social and Environmental Responsibility Code of Conduct. Click Here - Anti-bribery and Corruption Policy. Click Here - POPI Policy/Notice. Click Here - PAIA Manual. Click Here Invicta Holdings Limited T: +27 (0)11 620 7300 Engineering Solutions Group BMG T: +27 (0)11 620 1500 W:www.bmgworld.net

Mounting Instructions: Enclosed Style T-100 Ball Thrust Bearing is generally installed so that the race A is centered by the shaft and rotates with it. The race with the sleeve attached to it and having a clearance bore A’ is seated against a fixed part of the machine and is stationary. If installed in a recess, a clearance of one-eight inch or more should be left around the outside diameter B so that the shaft should wear in its journal bearings; the thrust bearing will be free to follow without cramping or wedging the balls.

The T-100 Banded Thrust Ball Bearing is available in inch dimensions from 0.313″ through 6.5″ bore, 0.688″ through 8.75″ OD, and 0.313″ through 1.5″ height.

Locknut

The “V” grooved raceways on this bearing enable it to carry radial loads equal to 25% of its thrust load capacity, while decreasing the amount of friction created by a full contact round groove design.

The T-100 Banded Thrust Ball Bearing Series is recommended for use in exposed locations where protection from dust, dirt, water, or other foreign matter is required. The balls are retained between two hardened steel races banded together by a mild steel or brass sleeve on the outside diameter.