SKFBearingSelect

The TruRyde #GS-2250DL cross references to the National 442109 grease seal. The #GS-2250DL has an inside diameter of 2.250 and an outside diameter of 3.376 inches, and is a compatible replacement for your National grease seal.

AxleTek is who makes our etrailer brake assemblies like the #AKEBRK-35-SA. We have found that while not considered to be as much of a premium brand like the Dexter assemblies they work just as well and happen to cost a lot less. To put it a different…

SKFbearing

We do have a compatible grease seal for your 168255TC oil seal, however, we do not carry rubber coated seals in this size. The 168255TC oil seal was designed to work with oil bath hubs on a 3,500 lb axle. For the most part, axle manufacturers have…

I attached a picture of the mounting holes for the Bulldog Heavy-Duty A-Frame Coupler, #BD44150WH301 that you referenced for you to check out so that you can compare them to the ones on your current coupler. Based on the picture you submitted this…

Timken pdf

Tom, unfortunately the controller 2020003067 is not going to work in place of the 289252, so It would need to be replaced with the 289252. I have also confirmed this with Lippert to make sure.

Though I may have an option for you, I was also unable to find any info on the T-23972 seal you currently have. With that being said, the Grease Seal - Double Lip - ID 1.719" / OD 2.565" - for 3,500-lb Axles - Qty 2 #RG06-050, or #58846 as…

NTNBearing

The Replacement Converter #PD4655V is the correct converter for your Parallax 7355 power center. I do not see that WFCO shows their 8955PEC being acceptable to use with your Parallax 7355.

Nachibearing

If you have the bearing numbers and the axle capacity, we may be able to find the right seal for your trailer. If not, you will need to take an accurate measurement of the outside diameter of your existing seal, or the inside diameter of the mounting…

If you're replacing the controller for your air conditioner system then you'd have to replace the whole distribution box as well because they wouldn't all mount the same and no two brands have been tested to fit together yet. The last…

To replace the oil caps on your trailer, you can use the Kodiak XL ProLube Oil Bath Hub Body and Cap, 1.98 Inch #xlprolube1980. This oil cap replaces the body and cap, with the cap being made from a blue polycarbonate. Based on the outer diameter of…

The specs listed for the #KDBC225DAC Kodiak caliper I found online match up with those of the Reliable CL-1000. Either would be compatible with a 3500 to 6000 lb axle but because it hasn't been officially tested, If I were in your shoes I'd…

Dexter and Hayes/Al-Ko make quality brakes and one isn't necessarily better than the other. The majority of the time, the biggest factor in determining the life of a brake is going to be the load it is asked to help stop, the ruggedness of the…