You’ll need a set of needlenose pliers. Test them before buying, to make sure they’re the right size; you want a snug fit. Be sure to use these tools carefully, and not to let young children handle them on their own.

How to remove bearing from housing

The important features of a car seal (sometimes known as a valve zip tie) for sealing valves are pretty basic. basically, it just has to be long enough to pass around the valve body, or nearby anchor point, and the valve operating wheel or lever.

How to remove bearing from shaft with puller

If you’re unable to remove a yo-yo’s bearing by hand, it may be necessary to use a set of pliers. Especially recently, high performance yo-yos have very tightly seated bearings, which are difficult to remove. Here’s instruction on how to properly remove it without damaging either the bearing or your yo-yo.

Since many yo-yos are equipped with size C bearings, common removers are also designed for size C bearings. If you have a yo-yo with a different size bearing, you will not be able to use a bearing remover for a size C bearing. Please check the size of the bearing on your yo-yo beforehand.

Things like seal head material, cable material, or the ability to uniquely identify the seals on the valves are also important features. If you require a specific feature in your car seals, why not let us know. We always try and accommodate the requirements of the car seal user.

How to remove bearing from shaft without puller

REWIND is a professional yo-yo store serving everyone WORLDWIDE. Our online store is based in Japan, however, we ship all over the world at a low fixed shipping rate or free shipping with orders of US$200 and more. We also have two actual stores in Aichi and Tokyo.

The way to remove the bearing is not to pull it straight out, but rather to rock it left and right to free it from its seat.

Bearing Removal Tool

If the yo-yo is disassembled and the accelerator (shaft) is attached to the body on the side with the bearing, remove the accelerator first. If the axle is still attached, it may hit the remover.If the accelerator is attached on the opposite side of the bearing, there is no need to remove the accelerator, so proceed to the next step.

With so many valve sizes to be sealed, anything from a few inches (cm) to 6ft+ (2m) long might be needed. The sensible approach is to stock a longer seal that fits all valve sizes, then just trim off the surplus after it’s deployed. But what other specification features might be important?