Timkenpillow block bearingsCATALOG

To make your job even easier, the collars in the race driver kit can be used with the SCA 6000 Kilogram Shop Press, allowing you precise control when installing bearing races and seals.

Timkendeep grooveball bearing CATALOGPDF

For driving seals into place, use the flat side of the tool which closest matches the outer diameter of your seal. Apply a little grease; and drive it into the hub using the same technique as with the bearing race.

Before inserting the new race, clean the area up with a clean rag, and use a wire brush to remove any stubborn grime or corrosion.

There are 9 different sized collars in the Bearing Race and Seal Driver set, to suit most wheel bearing sizes. Choosing the right one for the job is as simple as sliding a new bearing race over the tapered end of the collars - until you find the one with the best fit.

Timken ball bearing catalogrequest

Once all of the bearings are out, give the hub a good clean - mount it firmly in a bench vice, and drive the old bearing races out using a punch. Most hub assemblies have a relief cast into them, to allow the punch a proper purchase on the bearing race.

Timken ball bearing catalogpdf

The ToolPRO Bearing Race and Seal Driver kit will help you get the job done properly - without damaging your brand new parts.

TIMKEN ball bearingsize chart

Position the race on the hub, and hit the back of the handle with a hammer - to seat the bearing race all the way down into the hub. The collars are constructed of 6061 aluminium, which is softer than the bearing race to prevent damage, but still hard enough to stand up to regular use.

Your browser's Javascript functionality is turned off. Please turn it on so that you can experience the full capabilities of this site.

Start by parking your vehicle, or in this case – trailer – on a level surface. Jack up the wheel being worked on, support the axle using a rated stand – and remove the hubs by following a workshop manual.

The outer bearing should fall out easily, whereas the inner bearing will require the seal to first be removed - using a seal puller or a flathead screwdriver.