MB-20 Granite Polishing Kit

The following are AVERAGE directions. Different stones may require different techniques. If you are in doubt, don’t hesitate to call

Terms & Conditions: These chemicals are for professional manufacturing, research laboratories and industrial or commercial usage only. Not for medical or consumer use. We currently cannot ship this product to doctor offices, pharmacies, medical facilities, veterinarians or residences. All orders are verified prior to shipment. Orders shipping to consumers or medical facilities will be canceled.

mb-22® e-z polishing powder

An awesome wet polishing powder that will not etch surfaces with splatter. Formulated for calcite-based stones and terrazzo.

4. COUNTER TOPS: Target an area approximately 4 sq. ft. On the targeted surface, sprinkle 1 tablespoon of productin a circular pattern slightly smaller than the polishing pad you are using. Spray some water on the powder and overthe rest of the targeted area. Set the speed of the right-angle grinder/polisher (variable speed is a MUST) to the slowestspeed. Using a hog’s hair pad, move the machine over the targeted area slowly, applying steady pressure. Check thesurface for results after approximately 2 minutes. If you have a high polish, semi-flush the section and pull the slurrydown to next section and repeat.

All orders are processed within 3-5 business days (excluding weekends and holidays) after receiving your order confirmation email. You will receive an email notification when your order has shipped. Shipping times will vary depending on your location; if you need your prodcut ASAP there are expedited shipping options.

3. FLOORS: Target an area of approximately 10 sq. ft. In the middle of the target area, sprinkle approximately 2 oz. of product in a circular pattern slightly smaller than the diameter of the floor machine. Using a hog’s hair pad, position the floor machine with water on top of the powder. The machine cannot exceed 175 RPM for best results and needs at least 1.5 HP. Release 5 seconds of water and swiftly swing the machine back and forth over the targeted area to evenly spread the slurry. (Note: keep the slurry thick; not too wet) Polish slowly with a spiral motion moving from one end of the targeted area to the other and back. Continue polishing for 3-4 minutes. Then check the surface with a squeegee. You should have a high polish at this point. Next release just enough fresh water onto your target area to make vacuuming the used slurry easy. Then clean with a neutral cleaner such as MB-1 Floor Cleaner or MB-15 Stoneglow. Now repeat this process on next section.