Beststainless steel shoulder bolts

17-4PH Specifications: UNS S17400, AISI 630, ASTM A564-630, Werkstoff 1.4542, AMS 5604 Sheet, Strip and Plate, ASTM A 693 Plate

ASTM F593, Grade 630This specification covers seven groups of stainless steel alloys, with ASTM F593, Grade 630 applying 17-4PH. ASTM F593 Grade 630 covers the requirements for 17-4PH stainless steel bolts, hex cap screws, and studs sized 0.25 to 1.50 inches, inclusive, in nominal diameter. It is intended for common use and for service applications requiring general corrosion resistance.

Stainless steel shoulder boltssizes

17-4 shoulder bolts are available in 8 different aged (precipitation hardened) conditions offering a variety of mechanical properties (see below).

ohcanadasupply.ca has detected that your current browser has scripting disabled. In order for our site to function properly this setting needs to be enabled.

17-4 PH shoulder bolts are made from a precipitation hardened stainless steel most known for its exceptional strength and its ability to maintain its mechanical properties to 600°F. Compared to 316 stainless steel, 17-4 PH bolts yield strength is up over 4 times greater. When compared to Duplex 2205 bolts, the yield strength of 17-4 PH can be up to 2-½ times greater.

Stainless steel shoulder boltshome depot

Image

Shoulderbolt dimensions

To continue using our site to its fullest please follow this LINK to find instructions on how to properly enable this setting for your particular browser.

Image

Not what you were looking for? Check out our Fluid Handlers category. Click Here!

ASTM A564 GR 630This specification covers bars and shapes (such as fasteners) of age hardened stainless steels such as 17-4PH. It includes hot-finished or cold-finished fasteners that are produced by hot rolling, extruding, or forging. Grade 630 shall be furnished in the solution-annealed or or age-hardened condition.

17-4PH shoulder bolts, also called stripper bolts are a unique fastener with three main parts: head, shoulder, and thread. The head has the largest diameter and is where the torque is applied, typically with a socket driver. The shoulder is smooth and unthreaded, and has a set diameter and length. The shoulder’s role is to act as a shaft or dowel for rotating parts, axles for rolling parts, guides for sliding elements, and pivot points. The final part of a 17-4PH shoulder bolt is the threaded shaft. The threaded portion of a shoulder bolt has a major diameter slightly smaller than the shoulder diameter.