National Oilsealcross reference to SKF

GBSA Oil Seals deliver top performance and outstanding wear. They’re known around the world for their ability to prevent liquids and lubricants from leaking around rotary shafts and bearing housings. Oil Seals employ a rigid case and a flexible lip. They’ve become widely used because of low cost, easy installation and their ability to seal in a variety of applications.

Until the 1930s, hydroelectric-power plants equipped with water-turbine generating units produced the largest percentage of electric energy because they were less expensive to operate than thermal-power plants using steam-turbine units. Since that time, major technological advances have reduced the cost of thermal-power generation, while the cost of developing more remote hydroelectric sites has increased. By 1990, hydroelectric-power production constituted only 18 percent of global electric energy output. Thermal plants using nuclear energy or gas turbines to run steam-electric units are among these technological advances. Alternative electric energy sources include solar cells, wind turbines, fuel cells, and geothermal-power stations.

National oilsealcross reference chart

The wide-scale production and distribution of electric power was made possible by the development of the electric generator, a device that operates on the basis of the induction principle formulated in 1831 by the English scientist Michael Faraday and independently by the American scientist Joseph Henry. The first public power station employing an electric generator began operation in London in January 1882. A second such station opened later that same year in New York City. Both used DC systems, which proved inefficient for long-distance power transmission. By the early 1890s the first practical AC generator was built at the Lauffen power station in Germany, and service to Frankfurt am Main was initiated in 1891.

Cr seal interchangepdf

There are two primary sources for driving generators—hydro and thermal. Hydroelectric power is derived from generators and turbines driven by falling water. Most other electric energy is obtained from generators coupled to turbines driven by steam produced either by a nuclear reactor or by burning fossil fuels—namely, coal, oil, and natural gas.

Electric energy generated at a central power station is transmitted to bulk delivery points, or substations, from which it is distributed to consumers. Transmission is accomplished by an extensive network of high-voltage power lines, including overhead wires and underground and submarine cables. Voltages higher than those suitable for power plant generators are required when transmitting alternating current over long distances in order to reduce the power losses that result from the resistance of transmission lines. Step-up transformers are employed at the generating station to increase the transmission voltage. At the substations other transformers step down the voltage to levels suitable for distribution systems.

Cr seal interchangechart

GBSA Oil seals are available in a variety of designs and sizes including metal or rubber covered cases, spring or non-spring loaded lips, or specialty designs for severe conditions. Color can be provided to distinguish one component from another. Deliveries are among the fastest in the industry. We supply long or short runs with tooling costs that are surprisingly low. For additional information call our sales or engineering department at 800.837.4272.

Electric power is characterized by current or the flow of electric charge and voltage or the potential of charge to deliver energy. A given value of power can be produced by any combination of current and voltage values. If the current is direct, electronic charge progresses always in the same direction through the device receiving power. If the current is alternating, electronic charge moves back and forth in the device and in the wires connected to it. For many applications either type of current is suitable, but alternating current (AC) is most widely available because of the greater efficiency with which it can be generated and distributed. A direct current (DC) is required for certain industrial applications, such as electroplating and electrometallurgical processes and for most electronic devices.

electric power, energy generated through the conversion of other forms of energy, such as mechanical, thermal, or chemical energy. Electric energy is unrivaled for many uses, as for lighting, computer operation, motive power, and entertainment applications. For other uses it is competitive, as for many industrial heating applications, cooking, space heating, and railway traction.