skfspeedi-sleevecatalog pdf

For maintenance, we recommend greasing the bearings at least once per year through the installed grease zerk, and they should last just fine for a long time.

While this is advertised as a sealcoating shaft seal bearing, this part can be used in a wide variety of industrial applications.

Skfspeedi sleeve sizes chart

Just make sure to click the checkmark next to the gasket accessory before you hit the add-to-cart button and you're good to go.

The F207 is a 1-1/4 inch diameter flange bearing that works great for end-to-end rotating shaft needs like the agitation of sealcoating tanks.  If you've purchased one of our BIGA tanks in the past and need a replacement, these are the ones we use and will bolt up without a problem.

Speedi sleeve sizes chartpdf

We offer a wide range of Speedi Sleeve sizes. If there is a particular size you require then feel free to contact us with your enquiry or browse the SKF Speedi Sleeve catalogue below.

The F-2XX series flange bearings are designed to rotate within their housing which gives you some lee-way on positioning the shaft and bearings on each end.  For obvious reasons, we recommend that they are installed as straight and level as possible, but in case you're a little off, these bearings will give you a small amount of forgiveness if things aren't perfect.

Whether you're repairing your tank or building your own, pair the flange bearing with a rubber gasket to ensure your tank doesn't leak.

If you're building your own, we've used these bearings for well over a decade on our sealcoating tanks and haven't had any problems with them outside of the normal wear-and-tear.  Keep in mind, the OD of the shaft pipe or rod can not exceed 1-1/4" and we actually recommend using a shaft that is slightly smaller for easier fitment. If you need larger than 1.25 inch, you might want to look at the 1-1/2" flange bearing instead.